EdgeStar IB250SS - Winterizing; Recommissioning; Start Up; Condenser Cleaning

14
Remove the three
(3) screws from the
bottom of the
module and take off
the bottom plate.
Loosen the two (2)
screws attaching
the ice module to
the side of the
cabinet wall about
1/4 “. The ice
module hangs on
the screws so they
do not need to be
completely
removed.
Carefully remove
the ice module and
thermal pad (pad,
pictured here in
yellow, may vary in
color.) Pull the
power cable
through the
channel in the rear
of the cabinet.
Make sure not to
damage the
thermostat wire and
evaporator coil.