7
Refrigeration System Diagram
During the ice making stage the hot refrigerant gas is pumped out of the compressor to the
condenser. The hot gas is cooled by fan forced air after passing through the condenser. The
evaporator / ice module is cooled by the refrigerant. Ice is formed in the module after water from
the water inlet valve fills the ice mold. Low pressure refrigerant gas goes back to the
compressor from the evaporator.
During the ice harvest stage the ice module heater warms and the ice touching it is slightly
thawed and releases from the ice mold. The harvested ice then falls into the ice storage bin.
To Next Page
Loading...
