EdgeStar IB250SS - Replacing the Condenser Fan

18
Insert the water lines
into the new valve in
the correct ports by
simply pushing them
in until they stop.
The compression
fittings will hold the
lines securely.
Replace the blue
lock ring on the
module port.
Carefully reposition
the new water valve
in through the back
of the unit and
resecure it to its
bracket behind the
thermostat with the
two screws. Finally,
Replace the kick
plate.
Replacing the Condenser Fan
Remove the back panel and
locate the condenser fan.
Carefully lay the unit on its
back and remove the two
screws from the bottom that
secure the fan in place.