EdgeStar IB450SSP Service Manual

16
Ice Cubes Are Deformed or Wrong Size
Problem
Check point
Possible Cause
Correction
Ice Cubes Too
Small
Condenser
The condenser or fans are
dirty or the air vents are
covered.
Clean the condenser and
fans. Leave space around
the machine.
Ambient Temperature
The ambient temperature is
too high.
Adjust the ambient
temperature.
Electronic controller
The ice size is set too small.
See “Ice Cube Size
Adjustment Guidelines” in
this manual.
Refrigerant
Refrigerant leak.
Repair and recharge.
Ice Cubes Too
Large
Electronic controller
The ice size is set too Large.
See “Ice Cube Size
Adjustment Guidelines” in
this manual.
Sensor
The evaporator sensor is
defective.
Replace the sensor.
Ambient Temperature
The ambient temperature is
too low.
Adjust the ambient
temperature.
Ice Cubes Only
Partially
Formed or
Have Ragged
Sides
Water Quality
The water quality is poor.
Install a water-softener or
water filter in front of the
water inlet valve.
Spray Nozzle
Spraying is blocked by the ice
slide way.
Adjust the location of the
ice slide way.
Spray Bar
Spray bar obstructed.
Clean the spray bar see
the user's manual.
Water bin
Not enough water in the water
bin.
Check water supply filter
may be restricted.
Water Pressure
Water supply pressure is low.
Turn water supply on fully
to maximize pressure.
The Room
Temperature
The room temperature is out
the stated range.
Adjust the ambient
temperature.

EdgeStar IB450SSP Specifications

General

Brand	EdgeStar
Model	IB450SSP
Category	Ice Maker
Language	English