- 23 -
ENGLISH
SAFETY INFORMATION
7he MYA stove is designed to heat, through automatic pellet
combustion in the hearth, the room where it is installed, both
by radiation and the air that comes out of the front grille.
7he only risks that may derive from using the stove pertain
to non-compliance with installation instructions, direct contact
with live electrical parts (internal), contact with the ¿re or hot
parts (glass, pipes, hot air output), when e[traneous substances
or non-recommended fuel are introduced, or due to incorrect
maintenance.
Only use wood pellets as fuel.
Should components fail, the stoves are equipped with safety
devices that guarantee automatic shutdown. 7hese are activated
without any intervention required.
In order to function correctly, the stove must be installed in
accordance with the instructions given herein and the door
must not be opened during operation: combustion is fully
automatic and requires no intervention.
Under no circumstances should any foreign substances be
entered into the hearth or hopper.
Do not use Àammable products to clean the smoke channel
(the Àue section connecting the stove smoke outlet to the
chimney Àue).
7he hearth and hopper parts must only be cleaned when
&OLD.
7he glass can be cleaned when &OLD with a suitable product
(e.g. *lassKamin Edilkamin) and a cloth.
Do not clean when hot.
Make sure the stove is installed and ignited the ¿rst time
by Edilkamin-quali¿ed &A7 personnel (technical assistan-
ce centre) in accordance with the instructions provided here
within; this is an essential requirement for the validation of the
guarantee.
When the stove is in operation, the e[haust pipes and door
become very hot (do not touch without wearing the thermal
glove).
Do not place anything, which is not heat resistant near the
stove.
NE9ER use liquid fuel to ignite the stove or rekindle the embers.
Do not obstruct the ventilation apertures in the room where
the stove is installed, nor the air inlets of the stove itself.
Do not wet the stove and do not go near electrical parts
with wet hands.
Do not use reducers on the smoke e[haust pipes.
7he stove must be installed in a room that is suitable for
¿re prevention and equipped with all that is required (power
and air supply and outlets) for the stove to function correctly
and safely.
6KRXOGLJQLWLRQIDLO'2127UHLJQLWHXQWLO\RXKDYH
HPSWLHGWKHFRPEXVWLRQFKDPEHU
$77(17,217+(3(//(7(037,(')5207+(
COMBUSTION CHAMBER MUST NOT BE DEPOSI-
7(',16,'(7+(+233(57(',16,'(7+(+233(5
PRINCIPLE OF OPERATION
7he MYA stove produces hot air using wood pellets as fuel,
with electronically controlled combustion. +ereunder is the
e[planation of its functions (the letters refer to ¿gure 1).
7he fuel (pellets) is provided by the storage hopper (A) and,
to the combustion chamber (D) by means of a feed screw (B),
which is driven by a gear motor (&).
7he pellets are ignited by the air that is heated by an electrical
resistance (E) and drawn into the combustion chamber
by a smoke e[tractor (F).
7he smoke produced by combustion is e[tracted from the he-
arth by the same fan (F), and e[pelled via the outlet (*) located
at the bottom on the back of the stove, or on the top using an
optional e[tra (see page 29).
7he hearth is covered in cast iron, and closed frontally by a
glass ceramic door (to open use the dedicated “cold hand”
handle”).
Fuel quantity, smoke e[traction and combustion air supply
are all controlled by an electronic control board, which is
equipped with Leonardo
®
software to achieve high combustion
ef¿ciency and low emissions.
All phases of operation can be managed via radio remote
control.
7he stove is equipped with a serial port to connect an optional
cable (code 621240) to be connected to devices that allow
remote ignition (e.g. remote telephone, local thermostat).
A
B
C
D
E
F
G
¿g. 1
To Next Page
Loading...
Need help?
General
