30
Parameter Description
Beacon Interval Beacon Interval that specifies the duration between beacon
packets (milliseconds). The range for the beacon period is
between 20-1000 milliseconds with a typical value of 100.
DTIM Period Determines the interval the Access Point will send its broadcast
traffic. Default value is 3 beacons.
Data Rate The preamble defines the length of the CRC block for
communication among the wireless stations. There are three
mode including Long, Short and Auto. High network traffic areas
should use the shorter preamble type. If “Auto“ mode is selected,
the AP will auto switch the preamble mode depending on the
wireless adapters.
WMM Parameter Power Save (APSD) Enable – Enable this function to support
WMM Power Save.
Set Defaults
Set the setting values return to defaults.
Apply
Confirm the settings in the “Advanced“.
6.8.3 AP Statistics
You can get the real time information about the packet transmission and receiving status during
wireless communication from the screen. If you want to recount the statistics value, please click
“Reset“.
To Next Page
