13
►TROUBLESHOOTING
The device does not boot
• Make sure the power supply is connected
• Check power supply voltage
I cannot export conguration le
• Make sure your USB drive is working
• Make sure that the le system is FAT32
The modulated channel is not produced in the RF OUT
• Make sure that the TV set has a DVB-T MPEG4 tuner
• Make sure that the selected RF output channel number, is not the same as a received TV channel
or the same as from other modulator output
• In case the HDMI Modulator Xtend is connected in line with the aerial antenna, disconnect
the aerial antenna, connect only the modulator and try again
“Signal Loss!” message appears on screen
• Check the HDMI cable and connection, regarding the cable itself and the HD IN and OUT
• Make sure that the HDMI signal is compatible with the supported formats
Resolution not support” message appears
• Make sure that the source Video output does not exceed 1080p@30FPS resolution
To Next Page
Loading...
