Edison PRO - Page 12

D1 Filament Loading and Unloading (Continued)
Filament Loading and Leveling the Printing Bed
• When Unloading
1. To remove the filament from the extruder, select Utilities>
Filament Loading and select Unload Right or Unload Left
depending on which side you want to remove the filament.
2. When the extruder is completely heated with an alarm, locate
the extruder to the middle.
3. Pull the filament out of the extruder with the spring block
pressed.
∃DISON PRO User Manual V.1 12
4. Press the OK button to stop unloading.