© Edwards Limited 2020. All rights reserved. Page 19
Storage and disposal
D14643880 Issue L
6 Storage and disposal
6.1 Storage
Return the AIM Gauge to its protective packaging and store the AIM Gauge in clean dry conditions until required for
use.
When required for use, prepare and install the AIM Gauge as described in Section 3.
6.2 Disposal
Dispose of the AIM Gauge and any components safely in accordance with all local and national safety and
environmental requirements.
Alternatively, you may be able to recycle the AIM Gauge and/or cables; contact Edwards or your supplier for advice
(also see below).
The AIM Gauge and associated cables are within the scope of the European Directive on Waste Electrical and
Electronic Equipment. Edwards offer European customers a recycling service for the AIM Gauge / cables at the end
of the product’s life. Contact Edwards for advice on how to return the AIM Gauge/cables for recycling.
Particular care must be taken if the AIM Gauge has been contaminated with dangerous process substances or if the
AIM Gauge has been overheated or has been in a fire.
6.3 Return the equipment or components for service
Before you send your equipment to us for service or for any other reason, you must send us a completed Declaration
of Contamination of Vacuum Equipment and Components – Form HS2. The HS2 form tells us if any substances found
in the equipment are hazardous, which is important for the safety of our employees and all other people involved in
the service of your equipment. The hazard information also lets us select the correct procedures to service your
equipment.
We provide instructions for completing the form in the Declaration of Contamination of Vacuum equipment and
Components – Procedure HS1.
Download the latest documents from www.edwardsvacuum.com/HSForms/, follow the procedure in HS1, fill in the
electronic HS2 form, print it, sign it, and return the signed copy to us.
To Next Page
Loading...
Need help?
General
