© Edwards Limited 2008. All rights reserved. Page i
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
A652-18-880 Issue C
Contents
Section Page
1 Introduction .......................................................................................1
1.1 Scope and definitions ................................................................................................... 1
1.2 ATEX directive implications ............................................................................................ 1
1.3 Description ................................................................................................................ 2
1.4 ATEX certification ....................................................................................................... 3
2 NORMAL OPERATION .............................................................................5
3 ABNORMAL OPERATION ..........................................................................7
4 SYSTEM DATA ......................................................................................9
4.1 Physical data ............................................................................................................. 9
4.1.1 Dimensions ................................................................................................................9
4.1.2 Mass ........................................................................................................................ 9
4.2 Mechanical data .......................................................................................................... 9
4.3 Operating conditions ...................................................................................................10
4.4 Noise data ................................................................................................................10
4.5 Vibration data ...........................................................................................................10
4.6 Electrical data ...........................................................................................................10
4.6.1 Electrical data: single-phase pumps .................................................................................10
4.6.2 Electrical data: three-phase pumps .................................................................................11
5 INSTALLATION ................................................................................... 13
5.1 Safety .....................................................................................................................13
5.2 Mechanical installation ................................................................................................14
5.3 Electrical installation ..................................................................................................14
5.3.1 Check and configure the motor: single and three phase pumps ................................................15
5.3.2 Connect the pump to your electrical supply .......................................................................15
5.3.3 Connection of additional thermal protection devices ............................................................16
5.3.4 Check the direction of rotation ......................................................................................16
6 OPERATION ...................................................................................... 17
6.1 Pumping flammable/pyrophoric materials .........................................................................17
6.2 Gas purges ...............................................................................................................18
6.3 Shut down procedure ...................................................................................................18
6.4 Manual reset .............................................................................................................18
7 MAINTENANCE ................................................................................... 19
7.1 Safety information ......................................................................................................19
7.2 Maintenance plan .......................................................................................................19
7.3 Control intervals of ATEX coupling insert (EM40/80/175/275) ..................................................20
8 SERVICE, SPARES ................................................................................ 21
Index .............................................................................................. 23
For return of equipment, complete the HS Forms at the end of this manual.
Falcon 04069 04/2008
To Next Page
Loading...
Need help?
General
