Edwards GXS 750/2600

Descripon
Typical display
Dry pump speed in Hz DP SPEED 100 Hz
Booster speed in percent MB SPEED 100 %
Booster speed in Hz MB SPEED 100 Hz
Dry pump inverter temperature DP INV TEMP 100 C
Booster inverter temperature MB INV TEMP 100 C
Exhaust pressure EXHAUST 5 PSI
Exhaust temperature EXH PIPE TEMP 100 C
Water ow rate WATER 11.1 l/m
Run hours RUN HOURS 1000
Number of pump starts PUMP STARTS 100
Time to stop (seconds) TIME TO STOP 900
Acve alarms and warnings
Solvent soak SOLVENTSOAK O
Dry pump clean DP CLEAN O
Acve strain gauge ASG 3.4E+01 mbar
PT100 temperature PT100 1 108 C
Pressure transducer PR 105.0 kPa
PID auto tune status PID TUNE Normal
9.4.3 Setup menu
Press the SETUP buon to enter. The menu tle is shown at the top of the display. Scroll
by pressing the UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to exit back
to Normal menu.
Table 31
PDT setup menu structure
Descripon
Display
Commands menu* Command Menu...
Set sequences menu* Set Sequences...
Display inverter fault history menu Inv Fault Hist...
Soware version display menu S/W Version...
Display serial number Serial Num...
Fit accessory menu* Fit Accessory...
Edit IP conguraon menu IP Cong...
Edit display aributes menu Display Ar...
Set me and date Set Clock...
Display pump type Show pump type...
* This opon requires a security code to access it.
Each sub menu is described below.
Page 123
M58800880_H - Pump display terminal