Edwards iH1800HTX User Manual

A590-00-880
Issue D Original
Instruction Manual
iH Dry Pumping Systems
Description Item Number
iH80 A590-00-xxx
iH160 A590-10-xxx
iH160HTX A590-12-xxx
iH600 A590-20-xxx
iH1000 A590-30-xxx
iH1800 A590-40-xxx
iH1800HTX A590-42-xxx
iH1800NRV A590-50-xxx
iH1800NRV HTX A590-52-xxx
Where xxx is as follows:
460 V, 60 Hz, 3 phase 908
200/208 V, 50/60 Hz, 3 phase 945
380/415 V, 50 Hz, 3 phase 946
230 V, 60 Hz, 3 phase 957

Edwards iH1800HTX Specifications

General

Brand	Edwards
Model	iH1800HTX
Category	Water Pump
Language	English

Summary

Technical Data

2.2 Electrical data

Installation

3.1 Locate the dry pumping system

Instructions for positioning and securing the iH system, including lifting and levelling.

3.2 Lubrication

3.3 Connect the dry pumping system to your vacuum/exhaust system

Procedures for connecting inlet/outlet, exhaust, and vacuum pipelines.

3.4 Connect the iH1800HTX exhaust TMS

3.6 Connect the nitrogen supply

Details nitrogen supply requirements for optimum performance and safety.

3.7 Leak-test the system

Instructions for leak testing after installation to prevent leaks.

3.8 Electrical supply

Guidelines for connecting the system to the electrical supply safely.

3.10 Connect to your emergency stop circuit

How to connect to external control equipment for emergency shutdown.

3.11 Connect the cooling-water hoses

Steps for connecting cooling-water supply and return hoses, with safety warnings.

3.13 Commission the system

Steps for initial system startup, checks, and configuration.

3.14 Install additional safety equipment

Operation

4.1 Start-up

Procedures for starting the system, including checks and safety warnings.

4.3 Manual shut-down

Steps for safely shutting down the system via iTIM, PDT, or IM.

4.4 Automatic shut-down

4.5 Unplanned shutdown and alarms

Lists safety sensors and their corresponding shutdown conditions.

4.6 Emergency stop

How to use the emergency stop switch and its effects on the system.

4.7 Restart the pump after an emergency stop or automatic shut-down

4.8 Single equipment monitor (SEM)

Maintenance

5.1 Safety and maintenance frequency

5.2 Relocate the system for maintenance

5.4 General maintenance

5.5 Replace a fuse

5.6 Inspect the connections, pipelines, cables and fittings

Service, Spares and Accessories

7.2 Service