To Next PageTo Next Page
Need help?Do you have a question about the Edwards iH1000 and is the answer not in the manual?
General| Brand | Edwards |
|---|---|
| Model | iH1000 |
| Category | Water Pump |
| Language | English |
Provides detailed specifications including dimensions, mass, noise, vibration, and forces for iH80, iH600, and iH1000 models.
Details electrical specifications like supply voltage, frequency, full load, motor rating, and power input for various iH models.
Provides instructions and warnings for positioning the iH system, including lifting and securing methods.
Details connecting the iH system to vacuum/exhaust, including pipeline requirements and exhaust treatment.
Provides warnings and guidelines for connecting the system to the electrical supply, including category and earth fault protection.
Cautions on industrial product classification and connecting interface controls to avoid damage or shock.
Provides instructions and warnings for connecting cooling-water hoses, emphasizing electrical installation completion before turning on water.
Guides through the system commissioning process, including power-up checks, connections, and initial operation verification.
Details the procedure for starting the iH system, including checking supplies and control interface operation.
Explains how to perform a manual shutdown using iTIM, PDT, or IM, and the importance of isolating power.
Describes automatic shutdown conditions and the 'run 'til crash' mode, listing specific error numbers.
Explains the function of the emergency stop switch and its effect on the system, noting it's not an electrical isolator.
Outlines safety procedures for maintenance, including electrical isolation, cooling, purging, and PPE requirements.
