© Edwards Limited 2008. All rights reserved. Page 37
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A590-00-880 Issue D
7 Service, spares and accessories
7.1 Introduction
Notes: 1. Whenever you return the iH system to a Edwards Service Centre or other Edwards company, you must
comply with the requirements of Section 6 and with the requirements of the Return of Edwards
Equipment Procedure (refer to forms HS1 and HS2 at the end of Important Safety Information).
2. You must not drain the oil from the iH pump. You must clearly state the pump is full of oil when you
complete form HS2.
Edwards products, spares and accessories are available from Edwards companies in Belgium, Brazil, Canada, China,
France, Germany, Israel, Italy, Japan, Korea, Singapore, Switzerland, United Kingdom, U.S.A and a world-wide
network of distributors. The majority of these centres employ Service Engineers who have undergone comprehensive
Edwards training courses.
Order spare parts and accessories from your nearest Edwards company or distributor. When you order, please state
for each part required:
z Model and Item Number of your equipment
z Serial number (if any)
z Item Number and description of the part.
7.2 Service
Edwards products are supported by a world-wide network of Edwards Service Centres. Each Service Centre offers a
wide range of options including: equipment decontamination; service exchange; repair; rebuild and testing to factory
specifications.
Equipment that has been serviced, repaired or rebuilt is returned with a full warranty. Your local Service Centre can
also provide Edwards engineers to support on-site maintenance, service or repair of your equipment.
For more information about service options, contact your nearest Service Centre or other Edwards company.
7.3 Ordering accessories
Whenever you return the dry pumping system to a Edwards Service Centre or other Edwards
company, you must comply with the requirements of Section 6 and with the requirements of the
Return of Edwards Equipment Procedure (refer to forms HS1 and HS2 at the rear of this manual).
Table 8 - Accessories
Accessory Item Number
Pump display terminal 5-way XLR plug (PDT) D372-80-700
PDT extension cables XLR 5 way
3 m D373-70-591
5 m D373-70-592
10 m D373-70-595
15 m D373-70-596
25 m D373-70-597
To Next Page
Loading...
Need help?
General
