Edwards LaserSense HSSD-2

Chapter 3: Programming the unit
44 LaserSense HSSD-2 Aspirating Smoke Detector Installers Handbook
Menu Submenu Programmable function Page
Mains check enable (Yes/No) 50
Air Flow Aspirator speed (1-16) 50
Flow setup (Yes/No) 50
Sensor 1 enable (Yes/No) 51
Sensor 2 enable (Yes/No) 51
Flow pipe 1 - 4 51
Flow low 1 - 4 (0-99) 51
Flow high 1 - 4 (0-99) 51
Sensor 3 enable (Yes/No) 51
Sensor 4 enable (Yes/No) 51
Miscellaneous Chart rate (0-19) 51
Access code (0-9999) 52
BMS protocol (0-2) (command
module only)
52
Factory default (Yes/No) 52
Bus Setup (CM only) Scan for devices (Yes/No) 53
Numbers and addresses of
detectors
53
Looped bus (Yes/No) 53
Poll timeout (30-255) 53
Pager (CM only) Call center 53
Password 53
Pager 54
Page on fault (Yes/No) 54
Page on alarm (Yes/No) 54
Log Menu View event log 200 Events (000-127) 54
Diagnostic
Menu
Diagnostics Self-Test Mode (1-127) 54
Detector read Detector Read (1-127) 54
Loop errors Loop Errors (Port 1 and Port 2) 54
Dust separators 0 - 100% (1-127) 55
Relay test Aux 55
Pre-Alarm + Fault 55
Fire 1 + Fault 55
Fire 2 + Fault 55
Fault 55
Watchdog count Number of interruptions 55
Reset 40
Exit 40