11
Link
SYNCHRONISING THE TRANSMITTER AND DISPLAY UNIT
1. Start by inserting three AA/LR6 batteries into
the transmitter’s battery compartment, and
three AA/LR6 batteries in the display unit’s bat
-
tery compartment.
Tip: If the transmitter is located outdoors, it is
extra important to use good quality batteries.
Use Alkaline or preferably Lithium batteries
which tolerate cold better.
2. Press [Link] on the backside of the display unit.
The transmitter icon
will flash for a minute.
3. Press the button on the front of the transmit
-
ter once while the transmitter icon
flashes.
Wait until the icon stops flashing.
Tip: If synchronisation is successful, the
transmission icon
will show on the display.
– – – will show on the displayen
if unsuccessful.
N.B. The preinstalled update interval is six seconds. This means that the transmitter sends
updates every six seconds. It is possible to adjust this interval to 6, 12 or 18 seconds by
depressing the transmission button for two seconds (The LED colour will change).
• Red = 6 s.
• Green = 12 s.
• Orange = 18 s.
To Next Page
Loading...
Need help?
General
