SAFETY
IT IS VERY IMPORTANT THAT YOU TAKE INTO CONSIDERATION A FEW SIMPLE
PRECAUTIONARY MEASURES BEFORE USING THIS PRODUCT
Efergy energy meters are easy to install. Still, there are some essential safety rules that you must
be conscious of:
• In the UK or Ireland the installation of the energy meter is easy, since the only thing that is
required is to connect a sensor to the incoming mains power cable. If you still feel unsure as
to how to mount the sensor, we recommend that you contact a qualified electrician.
• In the Scandinavian countries a 3-phase system is used, which means that one must
install all three included sensors. The sensor clamps should be clamped over the incoming
electrical cables in or outside the distribution box. Contact a qualified electrician if you unsure
as to how to install the sensors.
• Read and follow the important information contained in the following pages. Remember that
the energy meter’s sensors do not need to have direct electrical contact at the measuring
point. The sensors should sit around the cable.
• If you find something unusual in or around the distribution box like loose cables, bare
cables, burn marks, openings in the insulation jacket or any other damage, etc. you must
immediately quit working and contact your electric company or the person responsible for
electrical installations.
• The cables must not be bent or overloaded when mounting the sensors.
If you are uneasy or have any questions regarding the mounting of the energy meter's sensors,
contact a qualified electrician immediately.
The sensors do not need to be removed during the lifetime of the equipment. However, batteries
need to be changed occasionally in the transmitter and display unit. The sensors do not have
any batteries that need to be changed.
To Next Page
Loading...
Need help?
General
