FINDING THE POWER SUPPLY CABLE FOR YOUR ELECTRICITY METER (SE) (NO) (FIN)
The Efergy energy meter is installed by clamping the sensor clips around the incoming mains
power cables leading to your electricity meter.
FINDING YOUR ELECTRICITY METER/DISTRIBUTION BOX
Find out where your meter is located. It is normally found on an outer wall, in the garage, in the
cellar or in a utility room. If you live in a flat, it may be located near the entry door, in the stairway,
or in the cellar. Make sure the cables exiting the bottom of the electricity meter are accessible.
Modern homes and flats can have safety panels which protect the cables entering the meter.
These are often sealed. Under no circumstances should the seals be broken other than by a
qualified electrician. Instead, we recommend that the sensors be installed after the main switch in
your distribution box.
If you still feel unsure as to how to mount the sensor, we recommend that you contact
a qualified electrician.
To Next Page
Loading...
