Wizard Up30 M Rev. 0 01/02/2018
Pag. 4
DANGER
In order to prevent third-party risks, the user, before starting the work cycle, must make sure that there are no
people or things near the machine.
DANGER
Carry out any type of operation on the machine only after wearing appropriate personal
protective equipment (protective gloves and goggles / protective shield).
DANGER
Report immediately to the owner of the machine and / or to the safety manager any faults or anomalies detected,
including those found on the pneumatic pump or on the connecting pipes.
The operator in charge of using the machine must be suitable for carrying out the work, must have a perfect
knowledge of how it works and how it should be used.
The operator must scrupulously follow the instructions contained in the manual to ensure his own safety
and of others.
Using a padlock, to be applied to the main supply valve, it is possible to prevent the use of the machine by
unauthorized personnel.
This machine has been designed, built and CE approved in accordance with the Directive 2006/42/CE (Machinery Directive) and to the EN 1493:2010.
The owner of the machine (or the employer) and the user must observe the following basic safety precautions:
The owner of the machine (or the employer) must allow its use only to qualified operators, trained using manufacturer's instructions for safe use of
the machine and correctly informed of its operation.
The owner of the machine (or the employer) must establish procedures to periodically inspect the machine according to the manufacturer's
instructions. The owner of the machine (or the employer) must make sure that the machine inspectors are qualified and that they are adequately trained
in the control of the machine.
The owner of the machine (or the employer) must establish procedures for the maintenance of the machine according to the methods and the
periodicity provided by the manufacturer. The owner of the machine (or the employer) must ensure that the technicians in charge are qualified and that
they are adequately trained in machine maintenance.
The owner of the machine (or the employer) must keep the inspection and periodic maintenance records required by the machine manufacturer.
The owner of the machine (or the employer) must keep this manual in a well-visible place near the machine and easily reachable by the operator
2.1 – WORKING PLACE
The working place must be kept clean and in orderly conditions. In particular, hazardous areas must be duly demarcated.
The working area around the machine and of any load devices must be free of obstacles.
Working tools and materials must not be left on the machine (or in places where they can interfere with mechanical
movements) and must not be left in places where they can fall and cause damage to people and / or things..
The used tools must be in good condition because any deteriorated tool, or in any case
under not optimal conditions, is a potential cause of danger.
To Next Page