SpeedStream PPPoE Modem
6
Ethernet Installation Method
1. Make sure the modem is not plugged into the electrical outlet.
2. Connect the Ethernet straight-through cable to the Ethernet port on the modem.
3. Connect the other end of the Ethernet cable to the Ethernet port on your computer.
4. Plug the telephone cable into the DSL port on the modem.
5. Plug the other end of the telephone cable into the telephone jack.
Note
If using a two-to-one adapter, plug the cable into the open socket.
6. Plug the power adapter into the modem and the electrical outlet.
When using the Ethernet installation method, you do not have to install any software. Refer to your
Internet Service Provider’s instructions for installing their software and/or connecting to the Internet.
You can now configure the TCP/IP settings as detailed in the next chapter.
To Next Page
Loading...