42
System software
11. Click Next on the computer screen.
12. At the Installation screen, click Next to start the installation. Wait while the files are
copied and installed. After files 1 and 2 are installed, you may be prompted to insert
Disk 2. If so, remove CD1, insert CD2, and then press OK (or, if you get the message,
“File not found. Insert Disk 2,” remove CD1, insert CD2, and then click Retry.)
The progress is slow at first. For most computers, expect to wait approximately 25
minutes to complete. Do not cancel.
NOTE: If you do cancel, click Finish and power off the Fiery X3eTY using its dedicated
AC power switch. Wait 10 seconds, and then repeat the installation procedure. If the
installation terminates abnormally, you may need to reboot the computer. To avoid
confusion, ignore the text and graphics on the Cancel screen.
13. Click Exit when the message is displayed that the installation is successful. Remove the
System Software CD2 from the computer.
14. Power off the Fiery X3eTY using its dedicated AC power switch.
15. Flip the service switches down to the normal position (away from the interface board).
16. Disconnect the cross-over cable from the LAN port and the Windows XP/2000 computer.
F
IGURE T Dismantling the isolated Ethernet network
X
indows 2000/XP
LAN port
Ethernet cross-over cable
To Next Page
Loading...
Need help?
General
