5.5.2 Manual On
You can switch the device on manually if the battery voltage is below
13.2 V/26.4 V (Lead batteries). After the start phase, the device is then in
"charging mode".
The device operates independently of the configured switch-on voltage,
and charges the battery until the cut-off threshold is reached.
(U
batt
>14.2 V/28.4 V and I
off
< 2.0 A/4.0 A)
Please note: The EFOY Pro fuel cell can only start if it is connected to an
intact battery and a filled fuel cartridge. The EFOY Pro fuel cell does not
switch on if the battery is damaged or has been deeply discharged.
INFO:
If the device fails to start, check that the cover lid is not still attached to
the exhaust hose connector. Remove the cover lid.
Press once on the operating panel if the de-
vice is switched off, or twice if the device is in
automatic mode.
To Next Page
Loading...
