Z Series Assembly Manual
© 2023 EFT Electronic Technology Co. Ltd. All Rights Reserved.
Preparations
Required t ools
1. Screwdriver Set: For tightening and loosening screws.
2. Extended screwdriver (M4, M5 models): For tightening and loosening s crews.
3. Screw g lue (provided): For locking screws, bolts and nuts.
4. Grease (provided): For sealling the plug.
5. Scissors/utility knife: For cutting wires, tape, etc.
6. Level: Used to level the motor set.
7. Hexagonal socket 6mm: For tightening and loosening the hexagonal stud at the locking buckl e of the arms.
8. Ordinary sa fety gloves.
In spection
• C heck the model, specification, the number of boxes, accessories, and t he compatibility of each parts according to
the list of items. If there are something wrong or m issing, please take photos as ev idence.
• C heck whether the components a re in good condition, whether the tripod is deformed, whether the internal flight
control is loose, whether the plug connector is skewed or falling off, whether there is any crack at the flow meter
connector, etc. I f there are any of the above s ituations, please contact customer service as s oon as possible.
Mount ing fi ttings
Arm locking handle and Motor base
The plug of t he signal cable
M4*35 Cylindrical s crew+M4 nut
Locking handle installation
To Next Page
Loading...
