Z Series Assembly Manual
© 2023 EFT Electronic Technology Co. Ltd. All Rights Reserved.
7. Adjust the arm handle to a suitable angle, use M4*12 screws to pass through the short pin of the handle, insert into the hexagonal
stud and t ighten.
8. Affix 'Watch Your Fingers' on the buckle of the arm and 'Mind The Blade' on the motor fixing place.
9. Follow the above steps to install the remaining arms and motors.
Step 3：Connect Cables
1. Pass each cable of the motors through the cable-passing seal , and then restore the seal.
2. Assemble the wire buckle to the frame, adjust the length of the cables to facilitate the insertion.
To Next Page
