HEDGE TRIMMER ATTACHMENT—HTA2000 23
◾
Vertical Cutting (with straight
blade)
Slowly swing the blade up and
down in an arc as you move along
the hedge – use both sides of the
blade (Fig. 12).
◾
Overhead Cutting (with blade at
an angle)
Hold the hedge trimmer vertically
and slowly swing it in an arc to
make maximum use of its reach
(Fig. 13).
WARNING:
Any overhead working
position is tiring. To minimize the risk of
accidents, work in such positions for short
periods only. Set the angle of the blade
to maximum so that the tool can be held
in a lower, less tiring position while still
providing adequate reach.
TO START/STOP THE TOOL
See "STARTING/STOPPING THE POWER HEAD" section in the power head PH1400
operator's manual.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING:
To prevent serious personal injury, remove the battery pack from the
power head before inspecting, cleaning, performing maintenance or changing add-on
attachments. A battery operated tool with the battery pack inserted is always on and
can start accidently.
12
13
To Next Page
Loading...
Need help?
General
