RF VISUAL INDICATOR (Amber)
On Transmission: Amber LED lights continuously for 1.5 to 3.5 seconds while
messages are being transmitted. The amber light also flashes after receipt of an
alarm cancel signal
Low Battery Indication: Amber light flashes every 10 seconds
Size of System: The recommended maximum is 12 Ei168RC units. In addition 8
further RadioLINK accessories (such as Ei407 Manual Call Point & Ei411H Remote
Control Switch) can be used. In some installations the RF range is likely to be the
limiting factor
Communication: All units will communicate together as shipped. After a unit has been
House Coded it will only communicate with other units House Coded at the same time.
House Coding is essential to prevent false alarms with, or from neighbouring systems.
The “Repeater” function will not operate until units have been House Coded
Entering House Code Mode: Pressing and holding the House Code switch until the
amber light illuminates, then releasing puts the RadioLINK Base into House Code mode.
House Code Mode: The RadioLINK Base transmits and receives specific codes.
The amber light will flash every 5 or 10 seconds (depending on number of units coded
- up to 12 units the flashes are every 5 seconds, above 12 units the flashes are every
10 seconds) to indicate the number of House Coded units in the system
Duration of House Code Mode: 30 minutes
19
To Next Page
Loading...
Need help?
General
