picking a part of the building, say the front wall of the building and then installing all
mounting plates in the same orientation with respect to this (see figure 6).
6. Carefully line up the Alarm on the base, gentle press home & twist on.
Install all the other Smoke Alarms similarly.
7. Press the Test button on each Alarm to ensure that it sounds (see Figure 7).
8. For hard-wired interconnected Smoke Alarms - see section 4.
,IXVLQJ5DGLR/,1.LQWHUFRQQHFWLRQVHHWKH¶5DGLR/,1.0RGXOH%RRNOHW·
Large
hole
nearest
front
wall
Orientate all
mounting plates
in the same
direction
if using
RadioLINK
Modules
Front Wall Front Wall
Mounting Plate Mounting Plate
Mounting Plate
Mounting Plate
Figure 6
13
To Next Page
Loading...
Need help?
General
