The latest design, materials and manufacturing techniques have been used in
the construction of Ei Electronics Alarms to minimise the effects of contamination.
However it is impossible to completely eliminate the effect of dust and insect
contamination, and therefore, to prolong the life of the Alarm you must ensure that
it is kept clean so that excess dust does not build up. Any insects or cobwebs in the
vicinity of the Smoke Alarm should be promptly removed. In certain circumstances
even with regular cleaning, contamination can build up in the smoke sensing
chamber causing the Alarm to sound. If this happens the Smoke Alarm must be
returned for servicing or replacement. Contamination is beyond our control, it is totally
unpredictable and is considered normal wear and tear. For this reason, contamination
is not covered by the guarantee and a charge is made for all such servicing work.
5.7 Smoke Alarm Replacement
The entire Alarm must be replaced if:-
7KH$ODUPLVLQVWDOOHGIRURYHU\HDUVFKHFNWKH´UHSODFHE\µGDWHPDUNHGRQ
the side of the Alarm).
,I WKH 6PRNH $ODUP LV JLYLQJ D ORZ EDWWHU\ LQGLFDWLRQ LH D VKRUW EHHS ZLWK D
simultaneous red light flash every 32 seconds. (Note: for an iSeries Alarm, if it
is not convenient to replace it immediately, pressing the test button will silence
WKH EHHSV DQG VWRS WKH UHG /(' IODVKLQJ IRU KRXUV 7KLV FDQ EH UHSHDWHG DV
required).
7KH$ODUPIDLOVWRVRXQGWKHKRUQORXGO\ZKHQWKHWHVWEXWWRQLVSUHVVHG
%HIRUHWKH$ODUPLVVDIHO\GLVFDUGHGUHPRYHIURPWKHPRXQWLQJSODWHWRXQSRZHU
the Alarm and to stop low battery beeps).
Do not put the Alarm into a fire.
22
To Next Page
Loading...
Need help?
General
