EINHELL TC-TS 254 eco User Manual

GB
- 33 -
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
•
The product meets the requirements of EN 61000-3-11 and is subject to special connection condi-
tions. This means that use of the product at any freely selectable connection point is not allowed.
•
Given unfavorable conditions in the power supply the product can cause the voltage to fluctuate
temporarily.
•
The product is intended solely for use at connection points that
a) do not exceed a maximum permitted supply impedance Zsys = 0.25 + j0.25, or
b) have a continuous current-carrying capacity of the mains of at least 100 A per phase.
•
As the user, you are required to ensure, in consultation with your electric power company if neces-
sary, that the connection point at which you wish to operate the product meets one of the two requi-
rements, a) or b), named above.
Anl_TC_TS_254_ECO_SPK9.indb 33Anl_TC_TS_254_ECO_SPK9.indb 33 25.10.2019 10:22:5125.10.2019 10:22:51

EINHELL TC-TS 254 eco Specifications

General

Input power	2050 W
AC input voltage	220-240 V
AC input frequency	50 Hz
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Number of teeth	24
Saw blade included	Yes
Product color	Black, Red
Package weight	20320 g

Weight and Dimensions

Depth	680 mm
Width	605 mm
Height	340 mm
Weight	16990 g
Table depth	555 mm
Table width	580 mm
Blade diameter	254 mm
Blade thickness	30 mm
Height adjustment range	0 - 80 mm