36
Chapter 4 SelfCalibration
4-2. Setting Monitor Date and Time
Set the monitor date and time.
Note
• When ColorNavigator is started, the date and time are automatically set. For details, refer to the ColorNavigator User’s
Manual (on the CD-ROM).
Procedure
1. Choose “SelfCalibration” from the Adjustment menu, and press
.
2. Choose “Settings” from “SelfCalibration”, and press
.
3. Choose “Clock Adjustment” from “Settings”, and press
.
The Clock Adjustment menu appears.
4. Set date with or , and press .
5. Set time with
or , and press .
Attention
• If the main power supply is disconnected for an extended period of time, the clock may need resetting.
4-3. Setting Calibration Schedule
Set the calibration schedule for SelfCalibration.
Procedure
1. Choose “SelfCalibration” from the Adjustment menu, and press
.
2. Choose “Settings” from “SelfCalibration”, and press
.
3. Choose “Schedule” from “Settings”, and press
.
The schedule setting menu appears.
4. Choose “Starting Time”, and press .
5. Set the “Starting Time” with
or .
Select the timing to execute SelfCalibration upon reaching the time set in the schedule.
Settings Function
Off SelfCalibration is not executed.
Power Save
To be executed under any of the following conditions.
• When the monitor is in “Power Save” mode or power is off at the set time.
• The monitor shifts to the power saving mode or the power is turned off when
the time period set in the schedule has elapsed.
Immediately SelfCalibration is executed immediately at the set time.
Press to exit.
6. Choose “Setting Type, and press .
Select the method for setting the adjustment schedule.
Setting Function Setting Example
Type-1 Execute once in every few months.
Execute once a month on Wednesday at 1:00 AM
of the rst week.
Type-2 Execute once in every few weeks.
Execute once every four weeks on Wednesday at
1:00 AM.
Type-3
Execute when the monitor usage time
exceeds the set time.
Execute when the monitor usage time exceeded
200 hours.
Press
to exit.
To Next Page
