Eizo CG247 - Setting the Calibration Targets

38
Chapter 4 SelfCalibration
4-4. Setting the calibration targets
In CAL mode, white point, color gamut and gamma can be set as adjustment targets.
Attention
• Adjustment targets will be applied only to the currently displayed CAL mode.
Procedure
1. Choose “Color” from the Adjustment menu, and press
.
2. Choose “Target” from “Color”, and press
.
The target setting window appears.
3. Choose “Brightness”, and press .
4. Set the target brightness with
or , and press .
5. Choose “White Point”, and press
.
The white point setting window appears.
- When setting color coordinates, select “White(x)” and “White(y)” and press . Then set the
respective values. Set within 0.2400 to 0.4500.
- When specifying color temperature, select “Temperature” and press .
Settings Function
4000 K to 10000 K Specify color temperature in units of 100 K.
Adobe
®
RGB Change to color temperature in conformance with Adobe
®
RGB.
sRGB Change to color temperature in conformance with sRGB.
EBU Change to color temperature in conformance with EBU.
REC709 Change to color temperature in conformance with REC709.
REC1886 Change to color temperature in conformance with REC1886.
SMPTE-C Change to color temperature in conformance with SMPTE-C.
DCI Change to color temperature in conformance with DCI.
Note
• When color coordinates are changed, the color temperature is changed to “User”.
Press
to exit.
6. Choose “Color Gamut”, and press .
The color gamut setting window appears. The color gamut dened by each standard can be selected.
Settings Function
Native Display images in the monitor’s original color gamut.
Adobe
®
RGB Display images in the color gamut dened by Adobe
®
RGB.
sRGB Display images in the color gamut dened by sRGB.
EBU Display images in the color gamut dened by EBU.
REC709 Display images in the color gamut dened by REC709.
REC1886 Display images in the color gamut dened by REC1886.
SMPTE-C Display images in the color gamut dened by SMPTE-C.
DCI Display images in the color gamut dened by DCI.
Note
• To set a color gamut other than those specied by each standard, specify the color coordinates of each RGB color at
“Gamut Settings”. The “Color Gamut” setting will automatically change to “User” at this time.
• Clipping can be set at “Gamut Settings”. For details on clipping, see (“To set clipping” (page 24)).