4 | Administrator Settings
28
– Display of video signals using USB-C
– USB Hub Function
– USB Power Delivery
– Screen InStyle (monitor control)
• "Off"
Disables the USB port so that USB peripheral devices cannot be used.
Note
• By pressing the switch on the far left for three seconds or more when the device's power is on
and when the Setting menu/Button Guide are not displayed, you can make the setting "On" (It
cannot be made "Off" at the same time).
USB-C Display Mode
Settings: "Normal" / "Extra"
If the monitor screen is not displayed even when a device that supports DP Alt Mode is
connected to the USB-C connector of the monitor, set this function to "Extra".
Note
• When this function is set to "Extra", the USB transfer speed is limited to a maximum of 480 Mbps
(high speed).
On-Screen Logo
Settings: "On" / "Off"
When the monitor is turned on, the EIZO logo and certification standard logo appears on the
screen.
When this function is set to "Off", the logos do not appear.
Key Lock
Settings: "Off" / "Menu" / "All"
In order to prevent changes to settings, the operation switches on the front of the monitor
can be locked.
• "Off" (default setting)
Enables all switches.
• "Menu"
Locks the
switch.
• "All"
Locks all switches except the power switch.
To Next Page
Loading...
Need help?
General