English
2. INSTALLATION
11
WARNING
Use the enclosed power cord and connect to the standard
power outlet of your country. Be sure to remain within the
rated voltage of the power cord.
Be sure to remain within the rated voltage of the power cord.
Not doing so may result in fire or electric shock.
The equipment must be connected to a grounded main
outlet.
Not doing so may result in fire or electric shock.
3. Turn on the monitor first, then the PC.
Turn on the monitor first, then the PC. The monitor's power indicator will light up
(green).
The monitor will warm up briefly, then display an image.
Whenever finishing your operation, turn off the PC and the monitor. (If an image
does not appear, make sure that all connections have been made properly. Refer to
the “5. TROUBLESHOOTING” (See page 23) for additional advice).
4. When using the software in the EIZO CRT Utility Disk: Connect the
upstream port of the monitor to the downstream port of the USB
compliant PC or another hub with the USB cable.
After connecting the USB cable, the USB function can be set up automatically. For
further details about the “ScreenManager Pro for USB”, refer to the readme.txt in
the CD-ROM.
NOTE
• Generally, for maximum viewing comfort, position the monitor
slightly below eye level. Staring at the monitor for prolonged
periods can cause eyestrain. Be sure to take adequate rests.
(A 10-minute rest period each hour is suggested).
To Downstream
Ports of the PC or
Another Hub
USB Cable
To Next Page
Loading...
Need help?
General