5
To become a team listening role, the prerequisite is that the other intercoms have been
paired to form a team simultaneously. The pairing steps is taken as followed.
Take an intercom that has been paired as a
paired server, entering listening mode pairing,
and press and hold <M Button> + <Volume ->
(about 5s) to prompt "Listen Mesh Pairing".
Note: Unjoined machines can only be joined again
through the server.
Take the intercom to be paired, enter listening mode
pairing, long press <M Button> + <Volume -> (about
5s), and prompt "Listen Mesh Pairing", the red light
and green light will flash alternately.
“Listen Mesh Pairing”
Red light and green light flash alternately
“Du”
“Channel n，xxx.x MHz”
“Listen Mesh Pairing”
Wait a moment and hear "Pairing Successful" from all intercoms. Wait a few more minutes and
hear "Channel n, xxx.x MHz". This means that you have joined the
intercom network and can communicate with others.
Pairing Steps as Listeners：
There are 5 channels in total, short press <M Button> + <
Volume ->/<Volume +> to switch channels
forward or backward. Note that the whole team needs
to keep the same channel to talk to each other.
Intercom Channel Switching
Short press the <M Button>, you will hear a
beep and the red light and green light will flash
alternately.
3
Red light and green light flash alternately
5s
5s
Paired Server
Paired Server
To Next Page
Loading...
