EJEAS MS20 - Bluetooth Intercom; How To Pair With The Device; Pairing with The Old Models

6
or
Simultaneously press and hold <Phone/Power
Button> + <Volume +> + <M Button> for
approx. 5 seconds to start pairing (red and blue
lights flash alternately).
For older models (V6/V4) follow the instructions to enter
the search and wait for successful pairing.
Red light and blue light flash alternately
After powering on the device, press and hold
<Phone/Power Button> + <Volume +> (about 5s)
until the red and blue lights flash alternately, and the
pairing voice prompts "Intercom Pairing". Wait for
connection to other intercoms.
Red light and blue light flash alternately
The other intercom enters the pairing state using the
same operation. After the two intercoms discover each
other, one of them will initiate the pairing connection.
B
A
FM
Bluetooth Intercom
How To Pair With The Device
Pairing with The Old Models
The connection is successful and the intercom begins.
5s
5s
5s
When both Mesh intercom and Bluetooth intercom
are enabled, when no one is speaking on the Mesh
network (including oneself), it will automatically
switch to Bluetooth intercom.
When someone is speaking on the Mesh network
(excluding oneself) while in Bluetooth intercom,
Mesh will automatically preempt and switch to Mesh
Intercom status, Bluetooth intercom is not working.
When you are in Bluetooth intercom and want to
speak to others on the Mesh network, simply press
the<M Button> to switch to Mesh intercom.
3