TECNOEKA Srl ___________________________________________________________ operating and instruction manual
page 18 _____________________________________________________________________________________________
When the cooking cycle is active the display reads: “COOKING IN PROGRESS”
When the cooking cycle is in “PAUSE” the display reads: “BAKING STARTS IN” (count-down)
With “BAKING IN PROGRESS”
: the display shows the count-down of the set time in the direction
of the symbol and on the right the total time set of the cooking cycle (of 1 or more STEPS).
Important
The value of the set parameter may be confirmed immediately in the PARAMETER SCREEN
with the “SELECT” key; otherwise, the value is confirmed automatically after 5”.
4.3.3.2 TEMPERATURE setting (Parameter screen)
With the “STEP” key the following may be set:
1. TEMPERATURE IN COOKING CHAMBER
2. CORE TEMPERATURE
3. DELTA T Value
1. TEMPERATURE IN COOKING CHAMBER
Use the keys and to increase or decrease the temperature (from 30°C to 260°C). After
that confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of the
symbol and the actual temperature detected in the cooking chamber in the direction of the
symbol .
2. CORE TEMPERATURE
Use the keys and to increase or decrease the temperature (from 0°C to 100°C). After
that confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of the
symbol and the actual temperature detected by the core probe in the direction of the
symbol .
When the OVERVIEW SCREEN shows the TEMPERATURE IN CHAMBER parameter and the
CORE TEMPERATURE parameter , to go back to setting the TIME parameter :
- Use the “STEP” key to select the CORE TEMPERATURE parameter .
- Use the “SELECT” key (the display shows the PARAMETER SCREEN);
- Use the “STEP” key to select the TEMPERATURE IN COOKING CHAMBER parameter ;
- Use the “SELECT” key.
At the end of these operations the display will show the red OVERVIEW SCREEN (if the
PREHEATING function is not set) to indicate the TIME parameter is missing (“00.00”).
To Next Page
Loading...
