eka EKF 611 CTC - Page 19

Electronic convection oven rev. .4___________________________________MODD. EKF 611 CTC – EKF 1011 CTC
_________________________________________________________________________________________ page 19
3. DELTA T VALUE
Use the keys and to increase or decrease the temperature (from 0°C to 100°C). After that
confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of and
the actual temperature detected by the core probe in the direction of the symbol .
The display shows the set temperature in the direction of the symbol and the actual
temperature detected in the cooking chamber in the direction of the symbol .
When the OVERVIEW SCREEN shows the CORE TEMPERATURE parameter and the DELTA T
parameter , to go back to setting the TIME parameter :
- Use the “STEP” key to select the DELTA T parameter ;
- Use the “SELECT” key (the display shows the PARAMETER SCREEN);
- Use the “STEP” key to select the TEMPERATURE IN COOKING CHAMBER parameter ;
- Use the “SELECT” key.
At the end of these operations the display will show the red OVERVIEW SCREEN (if the
PREHEATING function is not set) to indicate the TIME parameter is missing (“00.00”).
4.3.3.3 HUMIDITY/STEAM setting(Parameter screen)
Use the keys e to increase or decrease the humidity/steam value (from 10% to
100%). After that confirm the choice with the “SELECT” key.
4.3.3.4 “PREHEATING” setting (Overview screen)
Use the key and the display shows the relevant PARAMETER SCREEN.
Use the key (“ON”) to activate the function or the key (“OFF”) to deactivate it. In both
cases use the “SELECT” key to confirm the choice, otherwise it is confirmed automatically
after 5”.
During the preheating stage, the display reads “PREHEATING IN PROGRESS” and no value is
shown in the direction of the TIME parameter (---).
This means that the preheating time is not included in the cooking time.
When the preheating temperature is reached (temperature set in cooking chamber increased by
40°C: this temperature is maintained if the door is not opened), and intermittent buzzer goes off
and the words “PREHEATING OK OPEN THE DOOR” flashes on the display. Open the door, put
the food in the oven, close the door again: the cooking cycle starts automatically.
4.3.3.5 AIR FLOW SPEED setting (Overview screen)
The possibility to set 3 speed levels of air flows inside the cooking chamber makes it possible to
bake any type of food, from the most delicate and lightest to that needing higher heat
conveyance.