TECNOEKA Srl ___________________________________________________________ operating and instruction manual
page 20 _____________________________________________________________________________________________
Use key and the relevant PARAMETER SCREEN is displayed;
Use the keys and to set the desired speed level:
minimum speed ( )
medium speed ( )
maximum speed ( )
Use the “SELECT” key to confirm the choice, otherwise the choice is confirmed automatically
after 5”.
Important
The maximum speed is already pre-set for every cooking cycle
(
).
The key
may be used even during the cooking cycle to modify the speed level of fans.
Should this operation need to be performed during an already programmed cooking cycle, the fan
speed values will go back to those originally set upon creating the program.
“SEMI-STATIC” MODE
“Semi-static” baking is a mode that allows motors to be activated only when the heating
elements are operating.
The fans are activated for a few seconds, in order to distribute the heat generated by the heating
elements and make the temperature inside the cooking chamber even.
In this way static oven operation is reproduced.
To activate the “semi-static” baking mode operate as follows (from OVERVIEW SCREEN):
touch the key and the display shows the screen “AIR FLOW SPEED SETTING”.
Touch the key “STEP” to activate the “semi-static” baking mode: the words “ST OFF” turn
into “ST ON” which indicate successful activation.
Touch the key “SELECT” to confirm the selection: “ST” is displayed in the overview screen in
the direction of the icon indicating motor speed.
Fan speed may be modified also while baking in “semi-static” mode.
Operate as follows (from OVERVIEW SCREEN):
touch the key and the display shows the screen “AIR FLOW SPEED SETTING”.
Touch keys and to set the desired speed.
Touch key “SELECT” to confirm the selection.
4.3.4 Selection of cooking steps (Overview screen)
Each cooking cycle may consist of up to 9 STEPS. The desired parameters may be set for each step.
To move from one step to the next one, after setting STEP 1, act as follows:
touch key “STEP” to select STEP 1 (word highlighted on dark box);
touch key . The red OVERVIEW SCREEN is displayed reading STEP 2 (the red background warns
that the TIME parameter has not been set and therefore the selected step cannot be operative).
To Next Page
Loading...
