71
TV INSTALLATION TYPE
Press > > Sound > Additional Settings > TV Installation Type
This mode optimises the sound based on the TV setup.
Stand - Select this if the TV is installed in stand-type.
Wall-mounted - Select this if the TV is installed in wall-mounted type.
- This setting is only available for Internal TV Speaker
SETTING VOLUME MODE
Press > > Sound > Additional Settings > Volume Mode
Auto Volume - Click On to adjust the volume automatically for dierent broad-
casting companies so you can always listen to programmes at the desired vol-
ume, even after switching the programmes.
Volume Increase Amount - Select Low/Medium/High to adjust the volume range.
Higher values increase increments.
- This setting is only available for Internal TV Speaker.
DTV AUDIO SETTING
Press > > Sound > Additional Settings > DTV Audio Setting
When dierent audio types exist in an input signal, this function allows you to
select the audio type you want.
If set to Auto the search order is AC4 > HE-AAC > Dolby Digital Plus > Dolby
Digital > MPEG and output is produced in the first Audio Format found.
- The following search order may change depending on the country:
AC4 > HE-AAC . Dolby Digital Plus > Dolby Digital > MPEG.
- If the selected Audio Format is not supported, another Audio Format
may be used for output.
- Some models may not be supported.
ADJUSTING AV SYNCHRONIZATION
Press > > Sound > Additional Settings >AV Sync Adjustment
Adjusts the synchronization of the sound from the speaker that is working.
The closer to Greater than, the slower the audio output.
Bypass, Outputs the broadcast signals or the sound from external devices
without any audio delay. The audio may be output before the video because of
the time the TV takes to process the video input.
- Available options vary by Sound Out setting.
SETTINGS - SOUND (Cont.)
To Next Page
Loading...
Need help?
General
