- 12 -
For assistance please contact: http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU
6. SUPPORT AND SERVICE
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBoffi cial
7. SOCIAL MEDIA
Step B:
Plug the D-RGB connectors of the fans into the
D-RGB HEADERS on the HUB (x6 / x4).
Plug the D-RGB connector from the HUB
directly into the motherboard.
D-RGB Header
RGB Header
OPTIONAL STEP! APPLYING THE
THERMAL COMPOUND
This step is relevant only in the case of a
second installation of AIO or if you have
damaged the pre-applied paste on the
backside of the pump unit! For the fi rst
installation, you don’t need to apply the
additional thermal compound to the CPU’s
contact surface!
Wipe the CPU’s contact surface (using a
non-abrasive cloth or a Q-tip as shown in the
sample image). On a clean IHS, apply a line
of thermal compound and spread it over the
whole CPU heat spreader (IHS) with a credit
card or something similar.
Non-abrasive
cloth
IHS
To Next Page
Loading...
