- 10 -
STEP 5: MOUNTING BRACKETS
INSTALLATION (AMD)
Use four M4x4 screws to install two AMD
brackets onto the pump unit.
Be careful not to touch or damage the pre-
applied thermal compound!
M4x4
AMD
Mounting
Bracket
STEP 6: PUMP UNIT INSTALLATION
(AMD)
Wipe the CPU’s contact surface (using a
non-abrasive cloth pr a Q-tip as shown in the
sample image).
Align the pump unit over the mounting screws
and CPU as shown in the picture.
Place the enclosed compression springs and
thumb nuts over the mounting screws (4x). Start
fastening two thumb nuts at a time, preferably
in cross pattern, and do not tighten them fully
until all of them are partially screwed in.
Thumb Nut
Spring
Non-abrasive
cloth
IHS
STEP 8: PUMP – CONNECTING CA-
BLES (AMD)
D-RGB
Connector
VDG Connector
4-pin Connector
STEP 7: INSTALLING THE ASSEMBLY
OF FANS AND THE RADIATOR INTO A
PC CASE (AMD)
EK-AIO Elite 360 D-RGB / EK-AIO Elite 280
D-RGB
Option 1
Use the UNC 6-32 x 34mm screws to attach the
preassembled radiator-and-fans setup with the
remaining three / two fans (to have six / four
fans in total) to the PC chassis.
The orientation of the fans is crucial for
achieving the best performance of the radiator.
Install the fans so that they will push the air
through the radiator. To be sure about the fan
orientation, you can look at the position of
the EK logo on the side of the fan - it must be
oriented the same way on both the upper and
lower set of fans. It is also recommended that
cables of all fans are facing the same direction
for easier cable management.
Option 2
If there is not enough space inside your PC
chassis to place all six / four fans on the radiator,
you may position the remaining three / two
somewhere else inside your PC.
In that case, use the UNC 6-32 x 6mm screws
to attach the preassembled radiator and the
fans to the PC chassis.
UNC 6-32 x 34 mm
(12x / 8x)
EK-AIO Elite 360 D-RGB / EK-AIO Elite 280 D-RGB
To Next Page
Loading...
