ekwb EK-Quantum Kinetic TBE 120 VTX PWM - Direct Chassis Mounting

- 14 - - 15 -
CONNECTING THE PUMP
The EK-VTX Pump has two connectors:
1. 4-Pin Molex – must be connected directly to your
PSU at all times as it is used to power the pump;
2. 4-Pin PWM Fan – can be connected to your
motherboard CPU Fan or designated water pump
header. It can also be connected to a controller. This
cable is used to control and report the rotational
speed of the pump. If it’s not connected, the pump
will run at maximum speed (100% PWM).
4-Pin Molex
connector
4-Pin PWM
fan connector