EasyManuals Logo

Elan STROBE-1000-LED-RGB+W User Manual

Elan STROBE-1000-LED-RGB+W
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
1. Getting Started
1 x STROBE-1000-LED-RGB+W
1 x Base Plate
Safety Cable, An Eyebolt & Set of Mounting Brackets
Power Cord
User Manual
Carefully check the shipping carton for damage that may have occurred during shipping. If the carton
appears to be damaged, carefully inspect your unit for damage and be sure all accessories necessary to
operate the unit have arrived intact. In the rare event you find something damaged or missing, please
contact Acson Comercial or your local dealer for further instructions. Please do not return this unit to your
dealer without first contacting customer support.
Powering Up
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
AC Voltage Switch
Not all fixtures have a voltage select switch, so please verify that the fixture you receive is suitable for
your local power supply. See the label on the fixture or refer to the fixtures specifications chart for more
information. A fixtures listed current rating is its average current draw under normal conditions. Check the
fixture or device carefully to make sure that if a voltage selection switch exists that it is set to the correct line
voltage you will use.
Congratulations, you have just purchased one of the most innovative and relia-
ble lighting fixtures on the market today! Please read and understand the instruc-
tions in this manual carefully and thoroughly before attempting to operate this unit,
This manual contains important information regarding safety protocols that must be
strictly adhered to at all times.
Unpacking
Warning!
Verify that the voltage select switch on your unit matches the line voltage applied.
Damage to your fixture may result if the line voltage applied does not match the voltage
indicated on the voltage selector switch. All fixtures must be connected to circuits with a
suitable Ground (Earthing).
!
Getting A Hold Of Us
If something is wrong, please contact your dealer.
Disclaimer: The information and specifications contained in this document are subject to change without
notice. We assumes no responsibility or liability for any errors or omissions that may appear in this user
manual. We reserves the right to update the existing document or to create a new document to correct any
errors or omissions at any time. You can get the latest version of this document from your dealer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elan STROBE-1000-LED-RGB+W and is the answer not in the manual?

Elan STROBE-1000-LED-RGB+W Specifications

General IconGeneral
BrandElan
ModelSTROBE-1000-LED-RGB+W
CategoryTest Equipment
LanguageEnglish