16
6. Troubleshooting
7. APPENDIX
Symptom Solution
Fixture Auto-
Shut Off
If it is stopped or dimmer than normal, the unit may
have shut itself off due to high heat. This is to protect
the fixture from overheating.
No Light Output
Check to ensure fixture is operating under correct
mode, IE sound active/auto/DMX/Etc., if applicable.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse
Check AC cord and circuit for damage, verify that mo-
ving parts are not restricted and that unit’s ventilation
is not obstructed
Slow Movement Check that speed channels are set appropriately.
Fixture Not Responding / Responding Erratically
Make sure all connectors are seated properly and se-
curely. Use Only DMX Cables and/or check cables for
defects. Install a Terminator. Reset fixture(s).
Fixture Moving
On Its Own
Verify proper mode of operation. Is the fixture in “Auto”
mode?
Always disconnect power before cleaning never remove
the ground prong from power cord never spin a fan with
compressed air,
This can damage components in your fixture
!
Your fixture will require regular cleaning to prevent a build up of dust and smoke debris on the optics and
housing. After disconnection of power, wipe down the fixture with a damp cloth. Never use alcohol or sol-
vents as this may damage the finish. Use glass cleaner for glass surfaces such as external lens or mirrors.
A dry paint brush is an excellent tool to remove surface dust.
Be sure to periodically check for loose parts that could damage the fixture or potentially allow the fixture to
cause injury. Make sure all overhead and wall installations have a secondary safety device installed such
as a safety cable rated for your fixture type and size. Check the power cord as well, make sure there is no
damage that could cause electrical shock, never remove the ground prong.
There are no user-servicable parts in this fixture. Do not attempt to open and repair this fixture. Return to the
factory for repair
To Next Page
Loading...
Need help?
General