ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page 22 -
The BRAVO-FUNK-915 radio remote control system has been developed to ensure the best operating performance and
has some special features outlined below.
The symbols illustrated in this document are indicative and may vary from one model to another. Refer to the specic
documentation attached to the radio remote control.
8. BRAVO-FUNK-915 RADIO REMOTE CONTROL TRANSMITTING UNIT
START PUSHBUTTON AND LED INDICATORS
P2 is the Start pushbutton that, if pressed with the key in position 1, activates the radio link with
the receiver.
- Display of correct operation:
Pressing the Start pushbutton, the LED DL2 will light with the colour sequence Orange for 0.5
seconds, Green for 1 second and then green ashing with a frequency of 1 ash per second
- Display of Active Alarms Alert:
Pressing the Start pushbutton, the LED DL2 will light Orange for 1 second and then turns off.
Keeping the Start pushbutton pressed, the display becomes Orange for 1 second and red until
the Start command is released or the active command is excluded on the Start.
Note: an active command is any selector or joystick out of the rest or Zero position or the
mushroom Stop pushbutton when pressed.
- “Slow” mode
Turning the keyswitch selector to “Slow” (At symbol), slows the outputs of Joy2, Joy3, Joy4,
Joy7 in MOVEMENT mode only. The outputs have no variations in the other DRILLING and
PLACING modes.
To Next Page
Loading...
