• Five different auto-shutdown modes:
CONTINUOUS Transmission mode (CT). DISCONTINUOUS Transmission mode (DT).
- Auto-shutdown after 3 minutes of system inactivity.
- Auto-shutdown after 10 minutes of system inactivity.
- Auto-shutdown disabled.
- Auto-shutdown after 10 seconds of system inactivity.
- Auto-shutdown after 180 seconds of system inactivity
• Start/Stop option (see forward SPECIAL FEATURES):
CONTINUOUS Transmission mode (CT). DISCONTINUOUS Transmission mode (DT).
Removes the Stop function from command T1.
Assigns Start-on-rst-pulse function to command T12,
activates radio transmission and Stop on second pulse,
and then deactivates receiver.
Radio transmission can also be terminated by auto-
shutdown, depending on preset options
Not available.
• Acknowledged command transmission:
CONTINUOUS and DISCONTINUOUS Transmission mode (CT and DT).
Radio transmission is activated when the Start command is given and remains active only if the transmitter can
receive the acknowledge signal sent by the receiver. This function ensures that transmitted command reaches the
receiver, as transmitting and receiving units establish permanent communication.
• Automatic working frequency change:
CONTINUOUS and DISCONTINUOUS Transmission mode (CT and DT).
Radio transmission always occurs at low-noise frequencies thanks to the LBT (Listen Before Transmit) technology.
This technology enables the system to check that a frequency is free from noise or clear before using it. Whenever
communication between transmitter and receiver fails, the system will automatically and seamlessly change working
frequency.
• Electronic key:
CONTINUOUS Transmission mode (CT). DISCONTINUOUS Transmission mode (DT).
A sequence of three commands (Pin Code) to unlock the
Start command (T12) can be programmed.
Not available.
• Latching control:
CONTINUOUS Transmission mode (CT). DISCONTINUOUS Transmission mode (DT).
Each command - except the T12 and T1 commands - can
be set to latching mode. A latched command will remain
active after the rst pulse until the next pulse is given or
until the transmitter is switched off.
Not available.
Note:
The programmable functions may be blocked in radio remote controls with special features dedicated exclusively to
particular applications or kinds of machines, .
In particular, on a 4 buttons conguration the access to the programming menu is always inhibited.
To Next Page
Loading...
