ELCA MITO - 3.5 LATCHED CONTROL PROGRAMMING

ENG man MITO-MINI-915 04 Radio Remote Control System MITO-A-MINI
- Page 15 -
ENGLISH
3.5 LATCHED CONTROL PROGRAMMING
LATCHING
ENABLE
(submenu 4)
SUBMENU ACCESSED.
ACTIVATING ONE CHANNEL STORES
LATCHING MODE.
AUTOMATIC RETURN TO MAIN MENU;
WAIT 10 SECONDS AND SYSTEM EXITS MAIN MENU.
NOTE
- Latching can be programmed for any command except Start(T12) and Stop(T1), only in "START/STOP option" mode
can be programmed also for command T1;
- latching may only be set in continuous trasmission mode (CT);
- on standard radio remote controls, no channel is set to latching mode at the factory; latching must be enabled by user.
ACTIVATE CHANNEL OF COMMAND FOR WHICH
YOU WANT LATCHING DISABLED
AUTOMATIC RETURN TO MAIN MENU;
WAIT 10 SECONDS AND SYSTEM EXITS MAIN MENU.
T9
BLINKS TWICE
QUICKLY WITHIN
1 SEC.
FROM SUBMENU4,
ACTIVATE THE
CHANNEL YOU
WANT LATCHED
LATCHED CHANNEL ACTIVATES WITH ONE PULSE
AND IS DEACTIVATED BY A SECOND PULSE.
LATCHED CHANNEL IS DEACTIVATED WHEN
TRANSMITTER OR RECEIVER ARE SWITCHED OFF.
AUTOMATIC RETURN TO MAIN MENU;
WAIT 10 SECONDS AND SYSTEM EXITS MAIN MENU.
FROM SUBMENU4,
ACTIVATE
LATCHED
CHANNEL
any channel
except T1 and T12
any LATCHED
channel
ENABLING
FOR CT ONLY
DISABLING
FOR CT ONLY
FROM MAIN MENU,
ACTIVATE T9
BLINKS 3 TIMES
AT 1Hz
BLINKS 3 TIMES
AT 1Hz
CHANNELS
TO BE USED
WHAT TO DO
CHECK LIGHT
EXAMPLE: enabling latching command T11
T11
CHECK
T1
T12
T9
CHECK CHECK
STEP 1
access to
programming mode
STEP 3
enable latching
command T11
STEP 2
access to
latching submenu