10 SPARES & ACCESSORIES
www.elcometer.com
en-9
R
10.1 ADHESIVES
The adhesive supplied with the Elcometer 108 is Cyanoacrylate
Adhesive.
Cyanoacrylate adhesives are normally recommended for gluing dollies
to the sample area due to their relatively quick curing time. However,
there are a number of coatings for which the cyanoacrylate adhesives
may not be suitable. These are:
1 Thermoplastics, celluloses, vinyl, chlorinated rubbers and some
acrylics, due to the possibility of the glue reacting with the coating.
2 Porous coatings e.g. some metal spraying, in which case the
glue, due to its low viscosity will travel into the coating, sticking
particles together and possibly altering its adhesion.
®
A two-pack epoxy such as Araldite or a modified acrylic gel-type
adhesive should be used with the coatings described in (1) and (2)
above.
If in doubt as to the type of adhesive to use, please contact the coating
manufacturer for advice.
b
Cyanoacrylate Adhesive , 50g T99911135
®
Araldite Standard Two Part T99912906
Material Safety Data Sheets for the adhesives supplied by Elcometer can be downloaded via our
website:
www.elcometer.com/images/MSDS/elcometer_cyanoacrylate_adhesive.pdf
®
Araldite Standard Two Part Epoxy Adhesive:
Description Part Number
Cyanoacrylate Adhesive:
Epoxy Adhesive; 2x15ml Tubes
® ® ®
Note: Other suitable adhesives include Loctite Hysol 907 and Araldite Standard.
The suitability of any adhesive should be determined by the user. Some
coatings can be adversely affected by adhesives. Some adhesives can be
contaminated by coating environments, solvents etc.
www.elcometer.com/images/stories/MSDS/araldite_epoxy_adhesive.pdf
b
Supplied as standard with each gauge.
To Next Page
Loading...
Need help?
General
