www.elcometer.com
en-3
R
3 GETTING STARTED - DIGITAL PRESSURE GAUGE
1 Peel the protective rubber boot forward to expose the battery
compartment cover at the rear of the gauge.
3.1 FITTING THE BATTERIES
2 Rotate the battery compartment cover anti-clockwise to the
‘unlock’ position.
The battery symbol at the bottom right hand side of the display
indicates the battery condition.
Note: Batteries must be disposed of carefully to avoid environmental contamination.
Please consult your local Environmental Authority for information on disposal in
your region. Do not dispose of any batteries in fire.
To Switch On: Press . The gauge displays the version of
software fitted (e.g. 1.04.03 IDENT) followed by the MIN and MAX
range in MPa.
To Switch Off: Press and hold for a second. The gauge will
switch off when the button is released.
3.2 SWITCHING THE GAUGE ON AND OFF
3 Identify correct polarity and fit 2 x AA alkaline dry batteries.
Note: When the digital pressure gauge is switched off, “OFF” is permanently
displayed.
1 Press until TIMER is displayed followed by to select.
2 Press or to toggle between the options; NONE, 1 MIN,
5 MIN, 20 MIN.
Automatic Switch Off: The gauge has a timer function and can be set
to switch off automatically after 1, 5 or 20 minutes of inactivity. The
gauge default setting is NONE.
3 Press to select the setting required.
4 Replace battery compartment cover and rotate clockwise to the
‘lock’ position.
5 Replace protective rubber boot taking care not to damage the
front panel of the display.
MENU
MAX
MENU
To Next Page
Loading...
Need help?
General
