To access the language menu when in a foreign language:
1 Switch the gauge OFF.
2 Press and hold the left softkey and switch the gauge ON.
3 Select your language using the softkeys.
4.3 SCREEN SETTINGS
A number of screen settings can be defined by the user via
Menu/Setup/Setup Backlight including:
Backlight Brightness; This can be set to ‘Low’, ‘Medium’ or
‘High’.
Backlight Timeout; The display will dim if inactive for the
period defined by the user. To adjust the backlight timeout use
the softkeys to highlight ‘Backlight Timeout’ and press
‘Sel’. Use the softkeys to set the required value - between
0 (off) and 60 seconds - and press ‘Ok’ to set or ‘Esc’ to
cancel.
The gauge can also be set to switch off automatically after a user
defined period of inactivity - between 1 and 10 minutes - via
Menu/Setup/Auto Switch Off.
Note: ‘Auto Switch Off’ is disabled when the gauge is powered by the USB
connection.
4.4 SETTING UP THE READING DISPLAY
The user can select up to five climatic parameters to be displayed
on screen. Measurements are taken for all climatic parameters but
only those selected are displayed. Users can select from:
RH; % Relative Humidity
Ts; Surface Temperature
Ta; Air Temperature
Td; Dewpoint Temperature - calculated from Ta and RH
TΔ; Delta Temperature - the difference between surface
temperature and dewpoint
Tdb; Dry Bulb Temperature - equal to Ta
4 GETTING STARTED (continued)
www.elcometer.com
en-5
R
To Next Page
Loading...
Need help?
General
